Passenger side electrical harness Installation
- connect electrical connectors to main and secondary throttle position sensors (F).
- connect electrical connector to fuel tank breather valve (E) (driver’s side front of
engine block)
- connect harness cover to fuel injectors. Align each of the four connectors to the
injectors and firmly press the cover down using both hands.
- install two 10mm nuts and two washers (D), attaching harness cover head,
making sure cover is correctly aligned.
- connect circular knock sensor (B) and crankshaft position sensor (C) connectors
to passenger side cover, being careful to correctly route each harness.
- connect each of the four coils by lifting the locking plate and inserting the
connector down over the coil - ensure the lock plate is securely fastened.
- Install valve cover plate (2x 10mm bolts, A). Carefully install two small plastic
covering plates.
Komentáře k této Příručce