BMW R1150RT - MAINTENANCE INTEGRAL ABS Servisní příručka Strana 94

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 96
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 93
34.31
Integral ABS: Removing and install-
ing brake lines
Drain the brake system (a 34.16).
Push protective caps (1) up.
Remove spring clips (2).
Remove brake lines.
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
d Warning:
Always fit new spring clips each time the plugs are
disconnected. Ensure correct positioning.
e Attention:
Fit new sealing rings for brake line.
Secure brake line to master cylinder so that it can-
not become kinked or abraded when the handlebars
are turned.
L Note:
Always replace the seals (square-section rings) be-
tween the brake lines and the pressure modulator
when you replace the brake lines.
Carefully remove square-section rings (3) using
disassembly tool, BMW No. 34 2 561.
Install square-section rings with brake lines.
Check that square-section rings are correctly
seated.
Install new spring clips.
Slip the protective caps up the brake lines.
Clip in brake lines.
Check that spring clips are correctly positioned
(arrows).
Seat the protective caps on the connectors.
Fill and bleed the brake system (a 34.19).
X Tightening torque:
Brake hose and brake line............................ 18 Nm
Bleed screws in front brake calipers............... 7 Nm
Bleed screw in rear brake caliper................... 5 Nm
34 2 561
R28340160
3
1
2
Zobrazit stránku 93
1 2 ... 89 90 91 92 93 94 95 96

Komentáře k této Příručce

Žádné komentáře