BMW R1150RT - MAINTENANCE INTEGRAL ABS Servisní příručka stáhnout pdf (Strana 59)

00.54

12 12 011 Checking/replacing spark

plugs

(Inspection II) check/(Inspection III) replace

•

Pull off spark plug caps with special puller,

BMW No. 12 3 520.

•

Remove spark plugs with the spark plug wrench,

BMW No. 12 3 510.

e Attention:

Do not bend electrodes - risk of breakage!

Spark plug:..................................NGK BKR 7 EKC

Electrode gap: ........................ 0.8 mm (0.0314 in)

Wear limit:................................ 1.0 mm (0.0393 in)

X Tightening torque:

Spark plug NGK BKR7EKC.......................... 25 Nm

11 12 009

Tightening cylinder heads

(Inspection I)

•

Remove cylinder head cover.

e Attention:

Catch escaping oil.

•

Select a gear and turn the rear wheel, or set the

piston to TDC on the ignition stroke by turning

the belt pulley.

Top dead centre on ignition stroke:

•

The TDC mark is visible and the inlet and exhaust

valves in the cylinder concerned are closed.

•

Tighten cylinder head nuts.

Tightening procedure after 1,000 km (600 miles)

1. Tighten the cylinder head nuts one after the

other in diagonally opposite sequence

1.1. Slacken off one nut at a time

1.2. Tighten nut to initial torque.................... 20 Nm

1.3. Tighten nut to specified wrench angle...... 180°

2. Slacken/retighten M10 screw................ 40 Nm

R21000190

12 3 520

12 3 510

R21000330

R21000370

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 95 96

Komentáře k této Příručce

Žádné komentáře

BMW R1150RT - MAINTENANCE INTEGRAL ABS Servisní příručka Strana 59

Komentáře k této Příručce

Související produkty a manuály pro Motocykly BMW R1150RT - MAINTENANCE INTEGRAL ABS