BMW 5 Series touring (E 39/2) LHD Uživatelský manuál stáhnout pdf (Strana 15)

EN/15

9. To install the navigation computer

Cars without base holder only

Cut out the insulating mat (1) in the boot on the

left along the marked edge (2).

Insert expanding nuts S into the cross strut (1) in

the boot on the left.

Use self-tapping screws R to screw base support

system J onto the cross strut (1).

Use cap nut T to screw base support system J

onto the stud (2) on the boot floor.

All cars

Push speed nuts Q onto base support system J

and the cross strut (2).

Use hexagonal nut T to screw navigation

computer holder T onto the stud (1) on the rear

left wheel arch.

Use hexagonal screws P to screw navigation

computer holder K onto base support system J

and the cross strut (2).

Connect branches A9, A10 and B2 to navigation

computer L.

Push navigation computer L into navigation

computer holder K until it clips into place.

A10

1 2 ... 10 11 12 13 14 15 16 17 18

Žádné komentáře

BMW 5 Series touring (E 39/2) LHD Uživatelský manuál Strana 15